Outdoor work light NLPW series
Feature
A series-connected LED work light with lightning protection and no glare from LED lamp particles.
Ideal for lighting large spaces with connecting functions in factories, warehouses, construction sites and event venues.
The independently developed protection circuit design has a protective effect against inrush current, surges or instantaneous power outages, and has a high insulation safety design.
Using LEDs that are highly trusted around the world.
Applicable
Indoor/outdoor construction sites or sites with large light source requirements.
Specification
| color temperature | 5,700K |
|---|---|
| life expectancy |
Ambient temperature 25℃ 60,000 hours ※Life span is based on initial illumination reduced to 70% |
| Use temperature | -10℃～40℃ (referring to the condition without freezing) |
| protection level | IP65 |
| Standard wiring |
Cord with plug 5ｍ（VCT 0.75mm2x3C） ※Rainproof grounding plug |
| Body material | Polycarbonate (PC) |
| consume electricity | 9W / 20W |
| certification |  |
Gentle light source without flicker
The safe flicker rate recommended in IEEE 1789 (Standard for Effects and Evaluation of Lighting Flicker) is 8%, while flicker is almost undetectable to the human eye at about 3%.
Nikki product adopt an exclusive design to further reduce the flicker rate to less than 2%. Not only will there be no flicker at all when shooting general still photos and videos, but it can also use 240fps There will be no stripe flicker when shooting with high frame rate equipment. It is very suitable for application scenarios such as image inspection and appearance inspection that require high-precision photography or long-term naked eye observation.
※The picture below shows the situation under the light source of a Nikki product.
[General LED] Flickers and streaks may be observed during
photography
[Nikki product] Mild and even light, no flicker
Lightning surge protection
Use lightning protection design to prevent lightning surges, thereby protecting the lamps from damage caused by lightning. (Surge waveform 8/20μs, may cause 10KA discharge)
If a direct lightning strike or induced lightning strike occurs, surge waves may be conducted by wires, causing damage to electronic machinery. This lighting product is equipped with a surge protector containing lightning protection.
The line withstand is ±6kV
3 times the international standard
Withstand ±15kV to ground
3.75 times the international standard
Dimensional drawing
NLPW
| Model/size (mm) | A | B |
|---|---|---|
| NLPW10-AC | 1,110 | 870 |
| NLPW20-AC | 1,542 | 1,300 |
Installation example
